- 3 -
Opening the Stroller
1. Release folding latch by pull-
ing it forward.
2. Grip the handle bar on each side and
turn outward to open fully. (Holding
from underneath will make the pro-
cess easier.)
3. Lift up the handle bar and snap it
away from you. It will open and
automatically lock into position.
Attaching the Canopy
Attaching the Canopy
1. Confirm the canopies will attach on the proper side and
face the proper direction.
2. Fully insert the canopy holder (male) into the canopy
holder (female) until a click is heard.
3. Connect the hook & loop fasteners
located on both sides around the
handle and to the back of the seats.
Removing the Canopy
Pull the hook & loop fasteners
apart, squeeze the bottom of the can-
opy holder (male) and pull the canopy off.
Velcro
Canopy
Left
Canopy
Right
CAUTION
Failure to fully secure the canopy holders can cause the
holders to bend. When storing the stroller (by laying it
down), be sure the canopy is off the ground to prevent it
from bending.
Using the Stroller with Infant Seat
CAUTION
Infant seat must be attached to
stroller in rear facing position
only.
1. Recline stroller seat to the full recline position.
2. Pull the carrier attachment straps from behind the seat cushion.
3. Insert Combi Connection into left side of stroller seat (while facing the
stroller). Ensure bottom of Combi Connection child restraint rests on
stroller seat. Blue belt guide should rest against guardrail.
4. Bring the carrier attachment straps through the blue belt guides
located on each side of the infant seat/carrier and fasten the buckle.
(If the strap is the incorrect length, adjust as needed. To adjust, thread
fabric through each side of the buckle.)
Attaching Infant Seat
Removing Infant Seat
1. Unbuckle carrier attachment straps and lift child restraint
from stroller.
1
2
3
WARNING INFANT CAR SEAT MUST BE SECURED TO STOLLER USING
THE CARRIER ATTACHMENT STRAPS. AFTER INSTALLATION, LIFT CAR
SEAT TO VERIFY IT IS SECURECLY LOCKED ONTO STROLLER.
hook & loop
fasteners
hook & loop
fasteners