When the baby is growing bigger
Face-in cuddling position
• Cuddling position is divided into [Face-in cuddling position](P.13) and [Face-out cuddling position](P.16).
• When use in cuddling position, one should put on the base vest to which the cuddle-use cushion
has been attached, and then seat the baby into the carrier.
• The length adjustment snap must be snapped in shortened position for either face-in or face-out
position.
• Newborn baby whose neck muscle has not yet developed should use in cradle position.
Face-in cuddling position
(After
neck muscle has developed until ~ around 1
1.3kg)
Cuddle-use cushion
Base vest (Length adjustment snap in shortened position)
Parts required
Preparing the base vest
Setting the cuddle-use
cushion
Fasten the 2 lower buckles (male)
on the cuddle-use cushion to the
centre belt buckle (female) on the
base vest. Secure the snap.
1
12
way 2
Base vest
Snap
Cuddle-use cushion
Adjust the depth adjustment belt
Extend the depth adjustment belt to
increase the sitting depth of the cuddle-
use cushion when the baby is growing
bigger with its shoulders starting to lean
against the head support. (Refer to P.7 to
adjust the depth adjustment belt)
WARNING
The baby may have chance to fall off the
carrier if the sitting depth of the cuddle-
use cushion is too shallow.
CAUTION
Make sure both left and right side of the
belt end is of same length. Any imbalance
may cause the baby to fall off.
Apply the securing tape
After adjusting the depth adjustment belt,
set the lower end of the cuddle-use
cushion through the securing tape on the
base vest.
Check if the fabric is too thick to pull through
the securing tape.
CAUTION
Make sure to apply the securing tape
when the depth adjustment belt is
completely extended.
Securing tape
Lower end of the cuddle-use cushion
Summary of Contents for Ninna Nanna F-180
Page 24: ......
