27
Section 10 - Installing the Infant Car Seat Base With LATCH
28
Section 10 - Installing the Infant Car Seat Base With LATCH
Press down on the base and pull the
Lower Anchor Strap as tight as possible.
Excess Lower Anchor Strap can be passed
back under the routing tabs and through the
built-in Locking Clip.
See page 31 for information on using the
built-in Locking Clip.
Check that the base is securely held.
If the base moves easily more than 25 mm
(1") to either side, try another position, or
do not use the infant car seat in the vehicle.
When installing the base, ensure the bottom
of the base is in contact with the vehicle seat.
NOTE:
• See additional information on page 33
about putting extra support under the front
of the base.
Press down
firmly on base
Pull
Lower
Anchor
Strap
tight
ATTACHING THE INFANT CAR SEAT
INTO THE BASE.
Before putting the infant car seat into the base
make sure there are no objects on or in the
base.
Lower the infant car seat into the base.
NOTE:
• Listen for a "CLICK" when the infant
car seat is installed into the base.
• Llift the infant car seat to ensure the infant
car seat is fully connected to the base.
"CLICK"
To remove the car seat from the base, pull
firmly upwards on the release lever at the rear
of the car seat, and lift the car seat upwards.
WARNING:
• DO NOT use the infant car seat if it is
not securely connected to the base.
REMOVING BASE INSTALLED WITH LATCH
• Loosen lower anchor belt.
• Press and hold connector retainer spring.
• Unhook connector
• Store lower anchor belt inside base.
