For “Exclusion” from (removing from) a network: Put the Z-Wave Interface Controller into “exclusion”
mode, and following its instruction to delete the repeater from your controller. Press the program switch on
the once to be excluded.
Note: LED setting light will flash continuously in Exclusion condition.
3.
Use “Power Level Set” command for setting the strength of RF during one period.
4.
Use “Power Level Test Node Set” command to test the direct signal for fixed node.
5.
Support Repeaters for routing (FLiRS included)
6.
Support Explorer Frame function
7.
Press Program Switch for 5 seconds, the repeater will reset back to factory default.
Warranty terms
Comax Guarantees that every repeater sensor is free from physical defects in material and workmanship under normal
use for one year from the date of purchase. If the product proves defective during this one-year warranty period,
Comax will replace it free of charge.
Note:This warranty does not apply to
Damage to units caused by accident, dropping or abuse in handling, or any negligent use.
Units which have been subject to unauthorized repair, taken apart, or otherwise modified
Units not used in accordance with instruction
Damages exceeding the cost of the product
Transit damage, initial installation costs, removal cost, or reinstallation cost.