GENERAL SAFETY REQUIREMENTS
9
Comau Robotics Product Instruction
1.
GENERAL SAFETY REQUIREMENTS
This chapter contains the following topics:
–
–
.
1.1 Responsibilities
–
The system integrator is responsible for ensuring that the
is installed and handled in accordance with the Safety Standards
in force in the country where the installation takes place. The application and use
of the necessary protection and safety devices, the issue of the declaration of
conformity and potential CE marking of the system are the responsibility of the
Integrator.
–
COMAU declines any and all responsibility for accidents caused by incorrect or
improper use of the
Robotic system (Robot and Control Unit)
, by tampering with
circuits, components, software and with the use of spare parts that are not included
in the spare parts list.
–
The application of these Safety Requirements is the responsibility of the persons
assigned to direct / supervise the activities indicated in the section
which should make sure that the
is aware of and
scrupulously follow the requirements contained in this document in addition to the
general Safety Standards applicable to
Robotic system (Robot and Control Unit)
force in the Country where the system is installed.
–
The non-observance of the Safety Standards may cause to the operators
permanent injuries or death and can damage the
.
1.1.1 Essential safety requirements applied and fulfilled
The robotic system composed of Control Unit and SMART5 Robot series considers as
applied and fulfilled the following Safety Fundamental Requirements, Annex I of
Machinery Directive 2006/42/EC: 1.1.3 – 1.1.5 – 1.2.1 – 1.2.2 – 1.2.3 – 1.2.4.3 – 1.2.5
– 1.2.6 – 1.3.2 – 1.3.4 – 1.3.8.1 – 1.5.1 – 1.5.2 – 1.5.4 – 1.5.6 – 1.5.8 – 1.5.9 – 1.5.10 –
1.5.11 – 1.5.13 – 1.6.3 – 1.6.4 – 1.6.5 – 1.7.1 – 1.7.1.1 – 1.7.2 – 1.7.4.
This chapter deals with general specifications that apply to the whole Robot System.
Considering its significance, this chapter is referred unreservedly in each system
instructions handbook.
The installation shall be carried out by qualified Personnel and must conform to all
National and Local standards.
