InteliVision 5 CAN - 1.3.0, Global Guide
8
PC software
DriveConfig-3.9.0
DriveMonitor-3.0
Table 2.2 Available software
Installation Package
InteliDrive 3.8.0 Install Suite
Table 2.3 Available package
2.3 How to connect InteliVision 5 CAN to the
controller
2.3.1 Physical description
InteliVision 5 CAN is IP65 protected from the the both sides (front and rear). From that reason, there are not
present screw terminals for wire connection as generally used on ComAp controllers and displays.
InteliVision 5 CAN is equipped by 8-pins waterproof automotive connector on the rear side. InteliVision 5
Harness-2 cable (more details in
InteliVision 5 Harness-2 (page 17)
) or cable manufactured by customer has
to be used for InteliVision 5 CAN connection.
It is strictly recommended to use two ferrit cores on attached cable to the display in case of InteliVision 5 CAN
Backlit version is used in Marine applications. Ferrit cores suppress transmitted interferences from the display
to meet extended MARINE requirements given by Germanischer Lloyd standards. More details in
2.3.2 Address overview
Following table shows which display’s CAN terminal addresses are supported by the specific controllers, and
how many displays can be connected to the controller at the same time.
Supported
CAN terminal
addresses
InteliVision 5 CAN
InteliVision
5 CAN
Backlit
InteliVision 8
InteliVision
12Touch
I-RD-CAN
InteliDrive
DCU
*1
1, 2, 3
1, 2, 3
1, 2, 3
-
1, 2, 3
InteliDrive
DCU Marine
*1
1, 2, 3, 4, 5
1, 2, 3, 4, 5
1, 2, 3, 4
1,2,3,4,5
1, 2, 3, 4, 5
InteliDrive
Mobile
1, 2
1, 2
1, 2
-
-
InteliDrive
Mobile Logger
1, 2
1, 2
1, 2
-
-
