InteliSys
NT
-AFR-Abstract, SW version 1.0, ©ComAp – December 2006 18
IS-NT-AFR-1.0-Abstract.pdf
Users and Passwords
Up to 8 users can be defined in the system. Every user has it’s own defined level of access rights.
There are seven levels of password protection.
User O – Administrator has always level 7.
Hint:
The lock mark
±
appears before a set point name (on controller screen) if the setpoint is password
protected.
The lock mark is removed only when the password is set from controller’s front panel.
The lock mark is still visible on controller screen even if the password is set from different terminal.
Even though one level may have been set from the front panel, the affected set points are not
accessible from InteliMonitor (direct or Modem) until this level is set in InteliMonitor (direct or Modem).
Set point screen opened from front panel is automatically closed 15 minutes after the last key has
been pressed.
It is possible to protect remote Start, Stop, GCB and MCB commands from InteliMonitor. This seven
level command protection can be configured in GenConfig.
EnterPassword
Password is a five-digit number (0 - 65535). Only setpoints associated with the entered password level
can be modified.
Use
↑
or
↓
to select the desired password and then press ENTER.
Use
←
or
→
to move the value by 5% of the range.
