InteliPro, SW version 1.4,
©
ComAp
–
April 2014
InteliPro 1.4 Comprehensive Guide - rev. 1
2-9
Time (s)
Pick up value
Measured value
H
ys
te
re
si
s
Hysteresis limit
Pick up
Drop off
Voltage (V)
Voltage hysteresis for unervoltage
Overfrequency, Underfrequency (ANSI 81 H, L)
The frequency value measured on phase L1 is compared with the preset limit of overfrequency or
underfrequency. When any of the preset limits is over/underreached, the output
f Sig
moves to fault-
indicating position immediately. If the frequency keeps out of limits for the delay of the appropriate
stage,
is issued. As the frequency returns back within limits, the
f Sig
output stops to signal the
fault state immediately, regardless of whether
was issued or not or
not.
Both overfrequency and underfrequency protective stages provide possibility of setting 2 levels with
independent delay assigned to each level.
In order to prevent from unwanted frequency oscillation around the overfrequency, respective
underfrequency limits, there is a possibility to set up frequency hysteresis. The principle is shown in
the pictures below. After overfrequency situation, frequency must decrease under the hysteresis limit
to clear the fault. After underfrequency situation, frequency must exceed the hysteresis limit to clear
the fault.
Time (s)
Pick up value
Measured value
H
ys
te
re
si
s
Pick up
Hysteresis limit
Drop off
Frequency
(Hz)
Frequency hysteresis for overfrequency
