ComAp InteliLite 4 AMF 20, Global Manual

Page: 66 / 620

InteliLite4 AMF20 Global Guide
66
Following information has to be filled to establish connection:
IP address
Controller address
User name and Password
Access code is required
AirGate connection
You can use ComAp's AirGate service that allows you to connect to any controller via the internet regardless
of the restrictions of the local network (as long as the controller can connect to the internet AirGate service will
work). The following setpoints must be adjusted:
Controller Address (page 224) has to be set to the same value as in the PC tool
IP Address Mode (page 354) must set to AUTOMATIC when there is DHCP service available.
Otherwise it should be set to FIXED
IP Address (page 355) is either set automatically or it can be adjusted to a specific requested value
Subnet Mask (page 355) is either set automatically or it can be adjusted to a specific requested value
Gateway IP (page 356) can be set here when it is used
AirGate Connection (page 358) must be set to Enabled
AirGate Address (page 359) currently there is one AirGate server running at URL global.airgate.link
(enter this URL into the setpoint)
IMPORTANT: AirGate Key has to be configured. User with administrator rights has a possibility to
set up or change AirGate Key via InteliConfig using Tools -˃ Access Administration -˃ Change
AirGate Key.
IMPORTANT: Controller has to be connected to the Internet.
Getting started with AirGate
1. Make sure controller has link to Internet
a. CM3-Ethernet is connected to LAN infrastructure, has an IP address and access to Internet
b. CM2-4G-GPS is connected to a mobile operator (preferably to 3G/4G network) and has an IP
address
2. Connect with InteliConfig e.g. via USB and check setpoints as follows:
a. AirGate connection = ENABLED
b. AirGate port = 54440
c. AirGate address = global.airgate.link
3. Adjust AirGate key in InteliConfig – this is your "secret key" that you have to provide always when you
want to connect to the controller via AirGate.