InteliDrive DCU Industrial 3.4.0 Global Guide
161
Related FW
3.4.0
Related applications
AS, SS
Comm object
150
Description
If the input is closed, following commands received via any external terminal (e.g. from InteliMonitor or from
a remote display) are inactive:
Remote engine start, stop commands
No setpoints can be adjusted
Controller mode (e.g. OFF-RUN) cannot be changed
Fault reset and horn reset commands
All other commands (e.g. change of a Remote Switch state)
It is possible to list Setpoints, Values and History
Binary input functions are without change
Engine can be started, stopped via Binary inputs (e.g.
) or via front panel
buttons.
Note:
When this Access Lock input is active, it is still possible to initiate programming from a remotely
connected DriveConfig.
Note:
If you need to lock only some of the external terminals, you can use following inputs:
Device
Command
AccessLock int
AccessLock ext
LOC (Local) mode
ID-DCU Industrial panel
START
N
Y
Y
STOP
N
Y
Y
FLT RES
Y
Y
Y
HORN
RES
Y
Y
Y
Setpoint
change
N
Y
Y
Mode
change
N
Y
Y
ID-DCU Industrial Bin Inputs
Remote
Y
Y
N
InteliDrive local/remote commands blocking overview
Note: Y = available, N = blocked
AccessLock ext
Summary of Contents for InteliDrive DCU Industrial
