ComAp ID-Lite, Global Manual

Page: 91 / 225

ID-FLX Lite & Telecom Global Guide
91
9.1.2 Setpoints
What setpoints are:
Configuration of setpoints is possible through panel buttons as is described above or via ComAp PC tool
LiteEdit, where the setting can be open by click on the icon .
List of setpoint groups
Group: Basic settings 95
Group: Communication settings 103
Group: Engine parameters 111
Group: Regulator 126
Group: Load limit 132
Group: Engine protection 136
Group: Date/Time 164
Group: Sensors Spec 169
Group: AIO module 174
Group: Act. Calls/SMS 178
Group: ATT settings 180
For full list of setpoints go to the chapter List of setpoints (page 92) .
Password
EnterPassword
Password is a four-digit number. Password enables change of relevant protected set points Use ↑ or ↓ keys to
set and ENTER key to enter the password. There are 3 levels of passwords. Knowledge of higher password lets
you to change setpoint protected by lower password.
ChangePassword
Use ↑ or ↓ button to set and ENTER button to change the password.
Note: At first the Password has to be entered before the new Password can be changed.
Can be used LiteEdit PC tool for changes of Password level in window Modify press button Password for
each of three levels can be adjusted from the menu Controller->Change password…