Columbus Travel 600, Operating Manual

Page: 16 / 28

travel 600
16
Starting the travel 600

push machine into the travelator/escalator

push the foot brake with the foot and fix it.

turn key (3) of key switch (4) to position 1

switch on the machine by pressing ON switch (1)

switch (1) lights up

switch on the spray pump by pressing the switch 2.
4.6.1 Sideways movement of the travel 600
Without any problems the travel 600 can be moved sideways with the machine switched on and the trav-
elator/escalator moving.

after the first track shows the desired cleaning results put the machine onto the next track.

For this press switch (1), the brush-unit lift up.

Move the machine out of the escalator/travelator. Position the machine on track 2 with two
grooves of the already cleaned track 1 and track 2 overlapping. Under normal circumstances the
machine has to be reset two times in order to clean the complete travelator/escalator (from track
1 to track 2 and from track 2 to track 3).
Avoid or stop immediately the leaking of solution on the travelator/escalator. Damage of
the electrical or mechanical parts of the travelator/escalator could occur.
4.6.2 Finish the cleaning procedure
After the complete travelator/escalator shows the desired cleaning results the procedure can be finished.
 pressing switch (1) on operating panel (9).
 Move the machine out of the escalator/travelator.
Allow sufficient drying up time after the cleaning procedure.
Wet and slippery surface bear the risk of severe injuries.
Open the travelator/escalator for use only if the whole area is completely dried.
4.6.3 Disposal of waste water
For technical reasons there is cleaning solution and waste oil from the lubrication of the travela-
tor/escalator in the waste water.
Therefore it is important to observe the regulations on the disposal of substances with environmental
impact. Such substances are for example waste oil, cleaning solution, synthetic material or electrical
parts. Please get informed about the relevant disposal.