S
ECTION
3 — A
SSEMBLY
& S
ET
-U
P
Follow the steps below to complete handle assembly:
3.
1VMMVQXBSEPOUIFIBOEMFJODIFTVOUJMIPMFTJO
a.
lower handle (shown in Fig. 3-3 deck cutaway) line
VQXJUIIPMFTJOIBOEMFCSBDLFU4FF'JH
NOTE:
When pulling upward on handle, make sure to not
pull handle all the way out.
Insert the T-bolts removed earlier through the
b.
handle brackets and lower handle and tighten
TFDVSFMZUPTFDVSFUIFIBOEMFJOQMBDF4FF'JH
The rope guide is attached to the right side of the upper
handle. Loosen the wing knob which secures the rope
guide. See Fig. 3-5.
)PMECMBEFDPOUSPMBHBJOTUVQQFSIBOEMF
a.
Slowly pull starter rope handle from engine and slip
b.
starter rope into the rope guide. See Fig. 3-5.
Tighten rope guide wing knob.
c.
Use the cable tie provided to secure cable to the
d.
MPXFSIBOEMF1VMMUIFDBCMFUJFUJHIUBOEUSJNFYDFTT
8IJMFTUBCJMJ[JOHNPXFSTPJUEPFTOUNPWFQJWPU
b.
upper handle up as shown in Fig. 3-2. Do not crimp
cable while lifting the handle up.
Reattach bolts and wing nuts removed earlier into
c.
lower holes of handle as shown in Fig. 3-2 inset.
Remove the T-bolts from the handle brackets as shown in
2.
Fig. 3-3.
'JHVSF
'JHVSF
'JHVSF
"
B
B
B
$
$
Summary of Contents for Series A4
Page 22: ...22 Notes ...
