COLUMBIA VAC WGC50, Instruction Manual

Page: 10 / 36

10
EN
- Install the rear protective mesh (C) . The mesh
holes shall match the holes in the housing, Fig. 7 .
Fasten with the enclosed screws , Fig .8 .
- Slide the blade (B) onto the pin, Fig. 10 so that the
screw hole is directly above the indentation in the
pin, Fig. 9 and fasten with the screw ( attention –
the blade has sharp edges )
- Install the front protective mesh (A) . Connect both
meshes at the bottom with the enclosed screw,
and secure with clamps,
- Place the device on a stable and level surface Set
the switch (F) to “0” and connect the device to the
mains.
Use the switch (F) to select the fan speed (I, II, III).
To turn the device on, set the switch (F) to a chosen speed.
To turn the device off, set the switch (F) to “0”.
Regardless of the speed, the user can activate oscillations by pressing a push-button (E) .
To deactivate oscillations, depress the push-button (E) .
fot. 08 fot. 09 fot. 10
fot. 05 fot. 06
fot.
07