2 4/4/17
ALARM ZONES
This boat alarm has 3 alarm zones.
1.
Zone 1 uses normally-open alarm sensors. It is intended for
use with the canvas snap sensors and cable wrap sensors. If
an intruder unsnaps the canvas cover the alarm siren will
sound. The intruder will most likely drop the canvas and run.
Zone 1 will allow the siren to sound one time and then Zone 1
becomes inactive. As soon as the alarm is reset with the key-
fob remote control, Zone 1 is immediately active again in one
minute. (Zone 1 is the white wires that exit from the alarm
control box.)
2.
Zone 2 uses normally-open alarm sensors. (Zone 2 has the
green wires that exit from the alarm control box.) When the
alarm is active and a Zone 2 sensor has been triggered, the
siren will sound for two minutes. Then one minute after the
siren stops. The alarm will reset. If the alarm condition still
exists the siren will again sound-off. As long as the alarm
control receives an alarm signal from any sensor on Zone 2,
the alarm will continue to reset and the siren will sound-off
for a total of 3 times. Zone 2 is designed for use with the
following sensors.
Hatch or door sensors when the hatch of door closes
automatically.
PIR motion sensors.
Or any other normally-open sensor.
Summary of Contents for 411
Page 6: ...5 4 4 17 WIRING SCHEMATIC ...
Page 7: ...6 4 4 17 ...
