Changing the Center Of Gravity (Eclipse,Lil Dipper,)
The Center Of Gravity is changed by moving the rear axle position forward or
back. The following steps are how it is done:
1. Push the Rear Wheel Quick Release button. (Refer to “Quick Releases”
on page 16.)
2. Remove the rear wheel.
3. Loosen the large nut on the inside of the axle plate/camber plate.
Once the nut is loosened enough to free the guiding pin on the out-
side of the axle plate, move the axle receiver forward (to allow the
chair to tip more) or to the rear (to make the chair tip less).
4. Place the guiding pin in desired hole and re-tighten the nut on the in-
side of the axle plate. Make sure the guiding pin is completely posi-
tioned in one of the axle plate's holes before you tighten the nut.
5. Reinstall the rear wheel.
6. Repeat steps 1 thru 6 on the other rear axle. (note: The axles must be
set in the same position on both the right and the left side of your
chair.
Once you have determined your axle position, it is ex-
tremely important that the axle receiver is securely
fastened on the axle plate, by tightening the large
nuts that you released to move the axles. There should
be no play in the axle assembly.
3
C E N T E R O F G R AV I T Y
Changing the Center Of Gravity (Suspesion and Super tube style)
Because the shape of the frame on some models are slightly different, adjusting the
COG is accomplished by the following steps:
1. Push the Rear Wheel Quick Release button. (Refer to “Quick Releases” on
page 16.)
2. Remove the rear wheel.
3. Using an Allen wrench, remove the all bolts securing
the suspension mount or axle plate to the frame on each side of the wheel-
chair.
4. Slide the suspension mount or Axle plate forward or back to the
desired setting.
5. Reinstall the bolts on each side of the wheelchair.
Axle Plate (super tube)
3
THE SUSPENSION
ASSEMBLY MOUNT
4
3
4
6
O W N E R ’ S M A N U A L
