Figure E
ColorDMD Ground Cables
securely installed.
Route the new ColorDMD
Power Cable through the
access hole in bottom
of the backbox.
Red Stripe (J-1)
Red Stipe (J-2)
'Y' Harness:
Only use this to reconnect a
pre-existing cable back into
auxilliary 5v/12v power
source connector.
Plug into
ColorDMD
PWR
ColorDMD
Power Cable
Existing Auxilliary
5v/12v Power
Source Cable
Locate the included ColorDMD Power Cable. One end of the cable
has a single connector (see Fig. D). Plug this connector into the
PWR header (see Fig. B) on the ColorDMD circuit board.
ALL RIGHTS RESERVED - PATENT PENDING - COPYRIGHT 2013 - COLORDMD DISPLAYS LLC
Route the other end of the new ColorDMD Power Cable down
through bottom of backbox into the cabinet and over to the front
right-hand side of the game. (see Fig. E).
9
10
Figure D
STEP
STEP
TIP
Plug ColorDMD Power Cable into the auxilliary 5v/12v power
source connector (See Fig. E). If an existing cable is currently
plugged into this connector, disconnect it and plug it into the
other end of the ColorDMD Power Cable 'Y' harness (See Fig. D)
.
STEP
11
Route the new ColorDMD Power Cable inside the cabinet along
with other existing cables for a clean install.
Route to front
right-hand side
of cabinet.
