1.
To begin inflation, open external cap and pull
firmly on the lanyard to extend out. This will
open internal yellow seal. (Fig. 1)
2.
Attach adapter nozzle to inflation end of pump.
Insert pump and turn on. (Fig. 2)
Note:
The pump may look different from yours.
It is for illustration purposes only.
3.
When fully inflated, seal valve by pushing in
with pump nozzle. This will seal the internal
yellow stopper and keep air from escaping
while closing cap. Gently twist adapter sleeve
to right while backing pump out of valve. (Fig. 3)
4.
Fully remove pump and close external cap.
Valve should appear depressed into itself.
(Fig. 4)
Fig. 5
1.
Remove adapter nozzle
from inflation end and
attach to deflation side
of pump. Repeat same
steps as inflation. This
will draw the air out
quickly. (Fig. 5)
• Attach pinch valve
adapter to inflation end of
pump.
• Insert pinch valve adapter
into pinch valve. (Fig. 6)
• Make sure tip of adapter
is extended past inner “Flap” inside of
valve. Turn pump on.
• When fully inflated, remove pump from
valve and seal valve.
Fig. 6
Inflating Coleman
®
Double
Lock™ Valve
Deflation
Inflating Standard Pinch
Valve
Fig. 4
Fig. 3
Fig. 2
Fig. 1
4010045467 (ECN20060957-02)
•
Caution - Risk of fire and electric shock! Do
not operate for more than 10 minutes. Allow
30 minutes off between each operation.
Note: Pump will not work on stem valves
or needle valves commonly used on bike
tires, basketballs, etc.
Please call or write us with any comments or questions:
Coleman Brands Pty. Ltd.
Unit 5-6, 13 Lord Street,
Botany NSW 2019
Australia
Telephone: 1800 224 350
Email: [email protected]
www.colemanaustralia.com.au
Made in China
© 2017 The Coleman Company, Inc. All right reserved.
Coleman
®
,
, and are registered trademarksand
QuickPump™, Double Lock™, QuickBed™ and Wrap ‘N’ Roll™ are
trademarks of The Coleman Company, Inc.
