8
the top of any hill at high speed.
·
Always follow proper procedures for going downhill and for braking on hills
as described in this manual. Check the terrain carefully before you start down
any hill. Shift your weight backward. Never go down a hill at high speed.
Avoid going down a hill at an angle, which would cause the vehicle to lean
sharply to one side. Go straight down the hill when possible.
·
Always follow proper procedures for crossing the side of a hill as described
in this manual. Avoid hills with excessively slippery or loose surfaces. Shift
your weight to the uphill side of the ATV. Never attempt to turn the ATV
around on any hill until you have mastered the turning technique described in
this manual on level ground. Avoid crossing the side of a steep hill when
possible.
·
Always use proper procedures if you stall or roll backwards when climbing a
hill. To avoid stalling, maintain a steady speed when climbing a hill. If you
stall or roll backwards, follow the special procedure for braking described in
this manual. Dismount on the uphill side, or to either side if pointed straight
uphill. Turn the ATV around and remount, following the procedure described
in this manual.
·
Always check for obstacles before operating in a new area. Never attempt to
operate over large obstacles, such as large rocks or fallen trees. Always follow
proper procedures when operating over obstacles as described in this manual.
·
Always be careful of skidding or sliding. On slippery surfaces, such as ice,
go slowly and be very cautious in order to reduce the chance of skidding or
sliding out of control.
·
Avoid operating the ATV through deep or fast-flowing water. Avoid water
which exceeds the recommended maximum depth, go slowly, balance your
weight carefully avoiding sudden movements, and maintain a slow and steady
forward motion. Do not make sudden turns or stops, and do not make sudden
throttle changes.
·
Wet brakes may have reduced stopping ability. Test your brakes after leaving
water. If necessary, apply them lightly several times to let friction dry out the
pads.
·
Always be sure there are no obstacles or people behind you when you operate
in reverse. When it is safe to proceed in reverse, go slowly. Avoid turning at
sharp angles in reverse.
·
Always use the size and type of tires specified in this manual
“
17.
SPECIFICATION
”
. Always maintain proper tire pressure as described in this
manual
“
17. SPECIFICATION
”
.
