Spark Plug
To inspect the spark plug, remove
the air filter cover and element to
gain access. Remove spark plug cap
(1) then remove the spark plug from
the engine with the spark plug tool
provided.
Inspect the plug for carbon deposits
and clean if necessary. If plug shows
excessive carbon, replace the plug.
Use a thickness feeler to inspect the
spark plug gap (2). The spark plug
gap should be 0.6 - 0.8mm (0.024 -
0.032 in.)
0.6 - 0.8 mm
(0.024 - 0.032 in)
Re-install the inspected plug or new
plug until finger tight. Finish
tightening plug with a wrench. If the
plug is a new plug, tighten
approximately 1/2 turn more with the
wrench. If plug is an old plug, tighten
approximately 1/8 turn more with a
wrench.
2
Dirt can damage the engine if it
enters the spark plug hole.
Make sure the spark plug hole is
covered after removing plug.
CAUTION
1
MAINTENANCE
19
CHDY
F7TC
This Mini Bike comes equipped with a
CHDY
- F7TC spark plug.
