Safety information
8
Please read all the information in this manual before using the Alpha Cycler.
WARNING
HIGH TEMPERATURES ARE DANGEROUS: they can cause serious burns to operators and ignite combustible
material. Users should be aware of the following potential hazards:
• USE CARE AND WEAR PROTECTIVE GLOVES TO PROTECT HANDS.
• DO NOT use combustible substances near hot objects.
• DO NOT operate the instrument in the vicinity of inflammable liquids or gases.
• DO NOT place any liquid directly into the instrument.
• DO NOT touch the heated lid when system is running or within 10 minutes of the
system completing a run.
• DO NOT touch the block when the system is running or within 10 minutes of the system
completing a run.
OPERATOR SAFETY
All operators of PCRmax equipment must have available the relevant literature needed to ensure their
safety. It is important that only suitably trained personnel operate this equipment, in accordance with the
instructions contained in this manual and with general safety standards and procedures. If the equipment
is used in a manner not specified by Cole-Parmer Ltd. the protection provided by the equipment to the
operator may be impaired.
All PCRmax instruments are designed to conform to international safety requirements and are fitted with
an over-temperature cut-out. If a safety problem should be encountered, switch off the unit at the mains
socket and remove the plug from the electricity supply.
INSTALLATION
The instrument should be carried using both hands. Never move or carry the instrument when in use or
connected to the mains electricity supply.
The AC-2 / AC-4 have a weight of 30kgs / 47kgs respectively; it is advised that two people lift and carry
the AC-2, and three people lift the AC-4.
1. All PCRmax instruments are supplied with a power cable; this may be integral or plug-in.
2.
Before connecting the instrument to the mains electricity supply, check the voltage
against the rating plate (located on the back of the unit).
Please note that the unit
must be earthed to ensure proper electrical safety.
3. The units are rated to operate at: for the AC-1 100-230V, 50/60Hz and for the AC-2 / AC-4 100-
230V 50/60Hz.
4. Do not allow the Alpha Cycler to overhang the bench.
5. Ensure the bench for the AC-2 / AC-4 can withstand 30kgs / 47kg of weight.
6. Place the unit on a suitable flat and level bench or in a fume cupboard if required, ensuring that the
air inlet and outlet vents on the underside and rear are free from obstruction.
7. Ensure that the feet of the instrument do not overhang the side of the bench.
8. Plug the mains cable into the socket on the back (side in AC-2 / AC-4) of the instrument.
9. Switch on the instrument using the switch located on the back (side in AC-2 / AC-4 of the unit.
Summary of Contents for PCRmax Alpha Cycler 1
Page 1: ...PCRmax Alpha Cycler 1 2 and 4 Operation Manual PCRmax rev 10 ...
Page 62: ...Notes 62 ...
Page 63: ...Notes 63 ...
