1. Loosen 8 bolts with cross screwdriver (see Pic 3)
2. Pull up the 2 pieces of dust screens and side panel, then pull out side panel and take it out (see Pic 4)
3. Steps for installation are above in reverse.
To Add Water:
1. Pull out the water inlet chute from any side of the cooler (see pic 5)
2. Add water through this hole (see pic 6)
To Drain Water:
1. Open the valve cover at the back of the cooler. Close it clockwise after drain (see pic 7)
1. Check if cooler is at even level when assembling.
2. Check if drain pipe has been assembled.
3. Check the water supply to be sure there is no leakage.
4. Check the water level in the water tank. Do not overfill.
5. Check if the power supply connection is correct.
6. Check if the assembly and connection of the power control are correct.
7. Check if there is litter in the water tank.
8. Check if there is foreign matter in the fan motor.
9. Check if the power supply and voltage are normal.
10. Check if the running electrical current is in the rated range.
11. Check if there is any shake when running the cooler.
12. Make sure water is put in the water tank before running.
7. GUIDE FOR ADDING AND DRAINING WATER
8. CIRCUIT DRAWINGS
9. INSPECTION AND DEBUGGING BEFORE RUNNING
10. GUIDE FOR OPERATION
