Cold Jet i3 MICROCLEAN 2, Manual

Page: 18 / 64

12
Control Panel and HMI Screens
This i
3
MicroClean 2 uses a rotary encoder dial that allows the operator to navigate, select and adjust
settings on the control panel screen. You must first press the rotary encoder to activate navigation.
Navigate between options by turning the rotary encoder dial left or right; this will highlight the option
in blue. Once the desired option is highlighted, simply press the dial to select it; this will highlight the
option in green. With the option selected (green), turn the rotary encoder dial left or right to adjust the
setting then press again to accept.
Some options can be adjusted directly from the home screen while other options can be found on other
screens. To access these other screens using the rotary encoder dial, navigate to the settings screen
and press to select. Continue to navigate through the screens (i.e. recipe, status, applicator, advanced,
reset, settings) and adjust the settings as needed by turning and pressing the rotary encoder dial.
When not being used, the screen on the control panel will display a screen saver with feed rate, particle
size, air pressure, blast pressure and trough level. Press the rotary encoder dial to bring up the home
screen.
Figure 1: Control Panel and Rotary Encoder Dial
There are two screen states for the MicroClean 2. A blue screen (home screen) which is the system
operating and settings screen. A black screen indicates that the MicroClean 2 is in the advanced settings
or the recipe screen. Changes can be made in each screen.