Cognex ISC-8000 Series, Manual

Page: 5 / 90

Precautions
Observe these precautions when installing the Cognex product, to reduce the risk of
injury or equipment damage:
l
An IEEE 802.3af compliant, and UL or NRTL listed, Power over Ethernet
(PoE) power source rated Class 0, 2, 3 or 4 must be used. Any other
voltage creates a risk of fire or shock and can damage the components.
Applicable national and local wiring standards and rules must be followed.
l
To reduce the risk of damage or malfunction due to over-voltage, line noise,
electrostatic discharge (ESD), power surges, or other irregularities in the
power supply, route all cables and wires away from high-voltage power
sources.
l
Do not install Cognex products where they are directly exposed to
environmental hazards such as excessive heat, dust, moisture, humidity,
impact, vibration, corrosive substances, flammable substances, or static
electricity.
l
Do not expose the image sensor to laser light; image sensors can be
damaged by direct, or reflected, laser light. If your application requires the
use of laser light that may strike the image sensor, a lens filter at the
corresponding laser's wavelength is recommended. Contact your local
integrator or application engineer for suggestions.
l
The In-Sight camera does not contain user-serviceable parts. Do not make
electrical or mechanical modifications to In-Sight camera components.
Unauthorized modifications may void your warranty.
l
Changes or modifications not expressly approved by the party responsible
for regulatory compliance could void the user’s authority to operate the
equipment.
l
Service loops should be included with all cable connections.
4