Install the Lens Filter (S-Mount/M12 Lens Configuration)
Lens filters can be used to increase the contrast of images and improve the ability of the vision sensor to distinguish
desired characteristics. Lens filters are available for purchase as an accessory.
1. Verify that the 24VDC power supply is unplugged and not receiving power.
2. Remove the four screws and the cover from the optics module.
3. Unscrew the two screws on the filter holder and remove the filter holder from the cover.
4. Hold the filter by the sides, then push the filter in until it is sitting firmly against the filter holder.
Note
: Wear gloves when installing the filter to prevent leaving fingerprints on the surface of the filter.
21
Installation
