Cognex 800-5815-1, Installation And Reference Manual

Page: 39 / 57

Model 1460 I/O Expansion Module Installation and Reference
27
A.1.3 Line Details
Depending on which Line Type is chosen, an Output Details dialog may appear when the
Details button is selected. The Details Dialog associated with each Line Type is shown in
Table A-3. The Details Dialog parameter options are discussed following Table A-3.
I/O Module Standby
On means that the 1460 I/O Expansion Module has detected a loss of communi-
cation with the In-Sight sensor and is trying to re-establish the connection. The
line is Off as long as the 1460 I/O Expansion Module does not detect a loss of
communication between it and the In-Sight sensor. This type is only available
when “I/O Expansion Module” is selected.
Light Control (1460 only) Selecting the Light Control option will enable the Light0/1 outputs. This output
type is only valid for High Speed Output line 1 (HS OUT 1) when “I/O Expansion
Module” is selected.
1. The In-Sight sensor and strobe device must be connected to the same ground for the strobe to
operate correctly.
In-Sight 3400 and 5000 series sensors allow the Strobe output type only
on Line 1 of Standard I/O, and Line 9 (HSOUT 1) of the 1460 I/O Expansion Module.
Table A-3: Line Details Dialog
LINE TYPE(S) SAMPLE OUTPUT DETAILS DIALOG
Programmed
Acquisition Start
Acquisition End
Job Completed
Job Load OK
Job Load Fail
ERR: Missed Acquisition
ERR: Tracking Overrun
ERR: Tracking Queue Full
Table A-2: Discrete Output Dialog Type Parameter (Continued)
TYPE DESCRIPTION