12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12
.
Handling and cleaning instructions
1.
Open the Bag-in-Box at the perforation. Pull out the
silicon tube and the plastic connector, so it is clear of the
box.
2.
Place the box inside the dispenser. Press in the pinch
solenoid and slide the tube in to the opening. (Fig 2)
3.
Push the tube onto the ejector nozzle. (Fig3)
4.
The dispenser is now ready to use.
1.
When changing the Bag-in-Box, the dispenser should
be cleaned with hot water.
2.
Fill the rinsing bottle with a solution of hot water and a
sanitising agent. Add two drops of washing-up liquid.
Connect the tube to the nozzle and wash it through.
(Fig 4)
3.
Wet the brush in a hot water and sterilising solution.
Clean the outlet pipes by pushing the brush all the way
through the pipe and back again. (Fig 5)
4.
Rinse the pipes with the water solution from the bottle.
5.
The pinch solenoid that the tube runs through should be
cleaned on a regular basis, by pouring a hot water and
sterilising solution over it. This will dissolve any residual
concentrate.
6.
The air inlet (condenser) at the back of the machine should be
cleaned from dust on a regular basis by brushing or
vacuuming the grid.
Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.
