Fig 8-1
Fig 8-2 Fig 8-3
Finest position
loosen the securing screws silicone and body markers
Readjustment of grind setting
The grinder was factory set for different types of coffee powders, from finest
Turkish coffee to coarsest hand filter coffee. However, in course of time or
after thorough cleaning procedures or disks replacement, some changes in
setting may be required. If you feel your grinder is out of tune (either a
squeaking noise or grind powder is too coarse at the finest setting) please run
through the following procedure.
Release and pull the main grinding knob out.
The steel internal knob is exposed out now.
Note the current steel knob position (the relative position between the marker
on the knob to the marker on the main body)
Use a flat screw driver to slightly turn the steel knob clockwise in order to
make the pre-setting finer or counter clockwise in order to readjust the grinder
coarser.
Test the new setting, by running the grinder without coffee beans first. Then if
no an noise from on the new setting position use some coffee beans to test
the new position. Readjust accordingly.
Turn OFF the grinder, re-assemble the knob on Turkish coffee position,
tighten the screw and place the Logo cover back into its position.
Check the grinder by grinding coffee beans to various types of coffee powder
and repeat the entire process if necessary.
Coffee Laboratory 589 Rappahannock Drive White Stone Va 22578 TEL (804) 435-5522 www.coffeelabequipment.com
