Coffee Freshness CF055, Operation And Maintenance Manual

Page: 8 / 12

Coffee Freshness System Support either by email at ‘
​
support@coffeefreshness.com
​
’ or
by phone at (408)-649-4124.
6.3 Open the Airtight Canister lid as described in step 4.1.
6.4 Remove your dose of coffee.
6.5 Clean, close and secure the lid as described in sections 4.3 and 4.4.
6.6 Repeat step 5.2, start the preservation cycle by depressing the ‘VENT /
PRESERVE’ switch to the right.
6.7 Repeat steps 5.2 - 6.6 to perform the cycle of coffee preservation and dose
removal for brewing as often as needed.
Section-7: Procedure for removing the Airtight Canister from Base assembly
7.1 This procedure can be performed in either the Preservation (Pressurized) or Vent
(non-Pressurized) mode.
7.2 To remove the Airtight Canister while in the Preservation mode, turn the Main
Power Off by depressing the Main Power switch ‘I / O’ to the left. The Green LED on
the Main Power switch will turn off.
7.3 Release the Canister from the Base assembly by lifting the two securing levers
upward at the same time (Fig-6), then rotating the levers outward by 90 degrees away
from the lower edge of the Airtight Canister.
7.4 Lift the Airtight Canister upward such that the two notches at the bottom edge of
the Airtight Canister slide up and over the two posts on the Base assembly (Fig-5).
7.5 To remove the Airtight Canister after it has been Vented, follow directions in steps
7.3 - 7.4.
Section-8: Utilizing multiple Airtight Canisters - removing and installing Airtight
Canisters while in Preservation (Pressurized) mode
8.1 The Coffee Freshness System allows for Airtight Canister removal from the Base
assembly and installation on the Base assembly while in the Preservation (Pressurized)
mode. This allows the user to preserve multiple batches of coffee concurrently.
8.2 To remove an Airtight Canister from the Base assembly while in the Preservation
(Pressurized) mode follow steps 7.2 - 7.4.
8.3 To install a Pressurized Airtight Canister on the Base assembly, follow steps 3.2,
3.7 - 3.9.
8.4 To continue in Preservation mode for the newly installed Pressurized Airtight
Canister, turn on the Main Power by depressing the ‘I/O’ switch to the right followed by
starting the preservation cycle by depressing the ‘VENT / PRESERVE’ switch to the
right.
8.5 To vent the newly installed Airtight Canister in order to remove a dose of coffee,
turn on the Main Power by depressing the ‘I/O’ switch to the right. Since the the ‘VENT /