This function can be used to determine the operating mode of the projector (either
STAND ALONE
or
MASTER/SLAVE
), make pro-
gram selections or alter the crossfade times. Setting this function to on inhibits control via DMX signal.
9.1. MASTER/SLAVE mode
In MASTER/SLAVE mode, it is possible to control, via a projector set as MASTER, a series of
Par Lite Led IP
units set to act as SLAVE fix-
tures. The table below displays the settings required for fixtures to be connected in this manner.
To configure a
Par Lite Led IP as MASTER
is simply a matter of setting the
Auto
dip-
switch to the
ON
position and selecting a program for it to follow by making a selection
from the following dip-switches:
1-2-4-8-256
. There are 4 programs which can be select-
ed.
- dip switches
1-2-4-8
select programs 1, 2, 3, and 4 respectively.
- dip-switch
256
runs all four programs sequentially
To configure a
Par Lite Led IP
as
SLAVE
is simply a matter of setting the
Auto
dip-switch
to the
ON
.
All
other dip-switches should be set to
OFF
.
Par Lite Led IP
set to
SLAVE
ON
256
auto
test
light on
DR1
1
2
4
8 16 32 64 128
IR
SLAVE
ATTENTION!!
It is only possible to select one program at a time.
Par Lite Led IP
set as
MASTER
running program 1
ON
256
auto
test
light on
DR1
1
2
4
8 16 32 64 128
IR
MASTER
out
Ad altri
Par Lite Led SLAVE
Connect to other
Par Lite Led SLAVE
out
in
9. Auto function
14
English
