should never override any of the interlocks and safety mechanisms. These measures are taken for
your protection.
WARNING Use of controls or adjustments to the performance of procedures other than those
specified in this manual may result in hazardous radiation exposure.
The laser apertures are marked with a single label, shown below. There are three apertures that
correspond to the three cassette locations, one for each, on the same side of the Horizon imager as
this label.
Safety interlocks are marked by the following label. They are located on the same side of the
Horizon imager as this label.
Temperature Warning
Because the Horizon imager is a thermal print device, the surface of the thermal print head heat sink
gets hot. Avoid directly touching any components not colored green when accessing the interior of
the imager if the imager has been printing. (During some preventative maintenance tasks, you will
be touching internal components with cleaning pads or swabs.)
The temperature warning label is shown below.
Compliance
Codonics is in compliance with various regulations.
The Compliance label, which is affixed at the back of the imager, is shown below.
Serial Number, Configuration, Date Code, and Modification Codes
