8
6 Introduction to installation
Note: If any of the below operation is incorrect, turn off the power immediately and check the image
platform for any improper connections. Go through all steps again.
6-1 Installation - keyboard wedge
1.
Switch off the host and unplug the keyboard connector.
2.
Attach the phone jack connector of the Y-cable to the Host interface ① on the image platform.
3.
Connect the round female DIN keyboard connector ② of the Y-cable to the keyboard. Note that this
step may be not necessary for some devices.
4.
Connect the round male DIN host connector of the Y-cable to the keyboard port ③ on the host
device.
5.
Ensure that all connections are secure.
6.
Switch on the host system. If connect properly, the beeper and the LED of the image platform will
indicate.
Figure 6-1 Installation of keyboard wedge cable
