Code & Modules, Inc.
PixieBoard User Guide
Rev 1.1
20
4.
Certifications
4.1.
United
States
FCC
The PixieBoard complies with Part 15 of the FCC rules and regulations. Compliance with the
labeling requirements, FCC notices and antenna usage guidelines is required. To fulfill FCC
Certification, the OEM must comply with the following regulations:
The system integrator must ensure that the text on top side of the module is placed on the outside
of the final product.
PixieBoard platform may only be used with antennas approved. See FCC-approved antennas.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
‐
Reorient or relocate the receiving antenna.
‐
Increase the separation between the equipment and receiver.
‐
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
‐
Consult the dealer or an experienced radio/TV technician for help.
The FCC requires the user to be notified that any changes or modifications made to this device
that are not expressly approved by Code & Modules Inc. may void the user’s authority to operate
the equipment.
FCC
Exposure
warning
statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must be at least 20 cm from the user and must not be co
‐
located or
operating in conjunction with any other antenna or transmitter.
The information in this guide may change without notice. The manufacturer assumes no
responsibility for any errors that may appear in this guide.
