Using Your Remote Transmitter
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the LOCK icon button
on the transmitter. The horn will honk twice and the parking lights will flash twice,
indicating the system is armed. The doors will also lock at this time (if equipped and
connected). The status indicator (blue warning light on the dash) will blink steadily,
once per second. To arm the system silently, press and hold the LOCK icon button for 1
second. The parking lights will flash 2 times, indicating the system is armed, has
locked the doors (if equipped and connected) and activated the starter disable feature.
The status indicator (blue warning light on the dash) will blink steadily, once per
second.
Pre-arm Mode
If the horn honks and the parking lights flash only once, this indicates that the vehicle’s
interior light is on or an entrance is left open. Check to see that all doors hood and
trunk are closed properly. Once all entrances are secured (and the interior light is off),
this system will honk/flash again. The system is now fully armed. (If the entrance is not
secured within 4 minutes, the system will arm and ignore the unsecured entrance until
it is closed.)
Disarming the Security System
To disarm the system press the UNLOCK icon button. The horn will chirp and the
parking lights will flash once, and the doors will unlock (if equipped and connected).
To disarm the system silently, press and hold the UNLOCK icon button for 1 second.
The parking lights will flash, indicating the system is disarmed and has unlocked the doors (if equipped
and connected).
Disabling/Enabling Confirmation Chirps
1. Turn the ignition key ON then OFF
2. Within 10 seconds push and release the valet/override button 3 times.
3. The horn will honk 2 times to disable horn honks or 1 time to enable horn honks.
. Attempted Intrusion Identification
This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If
an intrusion attempt occurred, the horn will honk 4 times and the parking lights will flash 3 times when
disarming the system. Enter the vehicle an observe the dash mounted status LED to Identify which zone
was triggered.
1.
IT-s Sensor- 1 flash, pause 1 flash, etc.
2.
Hood or Trunk Pinswitch- 2 flashes, pause 2 flashes, etc.
3.
Door Entry- 3 flashes, pause 3 flashes, etc.
The intrusion warning indicators are stored in the system’s memory and will be erased when the ignition
key is turned on.
*Throughout this manual, ‘press’ refers to pressing for less than 1 second; ‘press and hold’ refers to pressing for more
than 2 seconds.
3
Summary of Contents for CA-125
Page 9: ......
