920-0546-00 Rev. A
Page 3 of 8
Installation Instructions: 2011+ Dodge Charger Version
Step 1
Fasten the CommandStik Mounting Brackets with the the supplied 1/4"-20 X 3/8” long screws, 1/4” internal tooth
lock washers, & 1/4” flat washers and tighten the screws finger tight (see Figure 1 below for bracket orientation).
Make sure
you thread the screws into the inner mounting holes in the brackets as shown.
Step 2
Remove the (2) outer child restraint covers shown in Figure 2 on page 4. Position the CommandStik in the rear deck
of the vehicle with the mounting brackets positioned in the child restraint pockets and align the threaded holes in the mount
-
ing brackets with the existing holes in the vehicle. See Figure 3 on page 4.
Step 3
Remove the fabric cover from inside the vehicle’s trunk, thread a supplied 1/4”-20 X 5/8” Phillips Pan Head Machine
Screw with a 1/4” internal tooth lock washer, & 1/4” flat washer through the existing hole in the child restraint area & into the
threaded holes in the Pemserts in each of the CommandStik Mounting Brackets (see Page 5 Figure 4). Leave the screws
just slightly loose.
Note: It is extremely helpful to have an assistant line up and hold the CommandStik’s Mounting
Brackets in location to prevent movement while you are threading the screws into the holes.
Step 4
Center the CommandStik in the rear deck area and tighten all of the screws. Replace the fabric cover inside the
vehicle’s trunk & snap the round plastic plugs into the holes in the top of the CommandStik to plug the holes.
Caution: Drilling into the housing of the light bar could damage wiring or other internal components.
Step 5
To replace the plastic child restraint covers you will have to trim the covers to clear the CommandStik’s Mounting
Brackets then re install the covers.
MOUNT TO
INNER MOUNTING
BRACKET HOLES
UNDER SIDE VIEW
PLASTIC
HOLE PLUG
1/4"-20 X 3/8" LONG
PHILLIPS PAN
HEAD SCREW
1/4" INTERNAL
TOOTH LOCK
WASHER
1/4" FLAT
WASHER
TOP SIDE VIEW
1/4"-20 X 5/8" LONG
PHILLIPS PAN
HEAD SCREW
FIGURE 1
