3
INITIAL SETUP
The diagram below illustrates the rear connections of the CP.
Note: Many amplifiers produce a local magnetic field that can be picked up by the sensitive
circuitry of a preamplifier. Try to provide at least a foot of space between your amplifier and
your CP preamplifier.
B
: Signal output is through two balanced XLR connectors and four unbalanced RCA
connectors. The XLR pinout is identical to the input receptacles.
A
: The AC receptacle accepts any standard three-prong IEC line cord. Power input can be
adjusted for any country, but is set internally at the factory. Contact Coda or your local Coda
dealer if the voltage must be changed. Fuse specifications are listed below the receptacle,
and the fuse can be changed by unplugging the line cord, pulling out the fuse drawer and
clipping in a new fuse.
C
: The Processor loop connectors permit the connection of an external audio device such as
a surround sound processor or equalizer. Connect the output jacks to the input of the
processor, and the output of the processor to the processor input jacks of the preamplifier.
D
: Signal input is through two balanced XLR connectors and eight unbalanced RCA
connectors. The XLR receptacle has ground on pin 1, positive on pin 2 and negative on pin 3.