Cocraft HSS 3.6-LI, Original Instructions Manual

Page: 10 / 56

EN
G
L
ISH
10
Information
• The screwdriver has two forward-pointing LEDs (8) which function as work
lights. The LED lights come on automatically when the trigger is pulled and
go off 5–10 seconds after the trigger is released.
• The screwdriver has an automatic spindle lock, which allows you to
use it as a manual screwdriver if the battery has been discharged or
the screwdriver is too underpowered to complete the job.
• The spindle lock is activated as soon as you begin screwing
the screwdriver manually. The maximum torque is 10 Nm.
• Do not overload the spindle lock.
• Do not pull the trigger when the spindle lock is on.
Care and maintenance
• Clean the product using a lightly moistened cloth. Use only mild cleaning
agents, never solvents or corrosive chemicals.
• If the screwdriver is not to be used for a long time, the battery should be
fully charged before the tool is stored away.
• Store the screwdriver in a dry place out of children’s reach whenever it is
not to be used for a long time.
Troubleshooting guide
The screw-
driver doesn’t
start. • The battery is discharged. Charge the battery.
• The overload or overheating protection has been
triggered. Let the screw driver rest and cool for a few
seconds before resuming work.
• Faulty power trigger. Contact our customer services.
The screwdriver
stops or is
sluggish. • The battery is discharged. Charge the battery.
• The overload or overheating protection has been
triggered. Let the screwdriver rest and cool for a few
seconds before resuming work.
• If the problem persists, make sure that the screw-
driver is not overloaded. Reduce the load.
• Is the task suitable for the screwdriver?
The battery
does not
charge. • Is the charger properly connected to the wall socket?
• Check that the wall socket is live.
• Is the battery correctly connected to the charger?
• Is the battery defective or too hot/cold?