Slide out the cover on the remote control. Insert the Phone Clamp
connector by sliding it down into place as illustrated
Unpack your Cocoonv FPV HD Camera Drone and check that you have
received all components as listed on page 11 of your manual.
Fully charge the drone’s battery before use, using the included USB
Charging Cable
a.
Use the QR Codes below, or search for ‘Drone Go’ to download the
drone’s application
b.
Switch ON both the remote control and drone
c.
On your phone, connect to WiFi Network ‘FPV_WIFI_****’
d.
In the ‘Drone Go’ App, click the Start icon to enter the control interface
Push the propeller guard into the slot and push the lever down until
you hear a ‘click’
a.
Switch ON both the remote control and drone by pressing the ON/
OFF buttons
b.
Move the left thumb stick up then down. You will hear two beeps
and the ON/OFF buttons on both devices will then change to solid
red to indicate pairing is successful
c.
To start the propellers, move the left and right thumb sticks
inwards and hold for 2 seconds. Refer to the Instruction Manual for
other take off methods.
Connect the camera wires to the plug port and insert the camera into the
base of drone by twisting the camera 90 degrees until it clicks into place.
The camera should always face forwards toward the head of the drone
Remove the battery cover and Install the 4 x AA supplied batteries into
the back of the remote control.
UNPACK
CHARGE & INSTALL
DRONE BATTERY
OPTIONAL: INSTALL THE
PHONE CLAMP TO USE
YOUR PHONE
ATTACH PROPELLER
GUARDS
PAIR THE REMOTE CONTROL
TO THE DRONE & ENGAGE
THE PROPELLERS
INSTALL THE REMOTE
CONTROL BATTERIES
INSTALL CAMERA
OPTIONAL: DOWNLOAD
THE FPV DRONE
APPLICATION
1
3
5
7
2
4
6
8
GETTING
STARTED
GUIDE
iOS App
(Version 8.0 or later)
Android App
(Version 4.1 or later)
Version 1.0