Cocoon HE170543, Instruction Manual, Page: 11 / 20

11
After Sales Support
1300 663 907
Model Number
HE170543
customercare@winplus.com.au
.
Installation
License Plate Mount Option
This installation is based on powering the
Camera using the reverse tail lights. When
installed as directed, the camera image will only
appear when the vehicle is in reverse.
CAUTION: This unit is designed to operate on
a 12V/24V DC NEGATIVE GROUND electrical
system. Connecting to other types of electrical
systems will cause damage to your vehicle.
Please contact the manufacturer if you are
unaware of the system type in your vehicle.
1.
Remove your license plate
2.
Determine the best route for the License Plate Mount Adapter from the top of your license plate to the
inside of the vehicle. You may need to drill a small hole in the panel behind where the license plate is
situated.
3.
Take the adapter and run the cable through the Rubber Ring Grommet, then from the outside of your
car to the inside. Pull the cable through so that there is a small amount of slack and you can still move
the Camera around the license plate.
4.
Locate the reverse taillights’ wiring behind your reverse light. You may need to remove the interior
panel in order to locate it. You only need to attach the adapter to ONE of the reverse lights, not both. If
you cannot manually locate the taillight cables, please contact the vehicle manufacturer or reference a
wiring diagram for your vehicle.
5.
At your taillight, remove the light bulb socket from the reverse light housing.
6.
Determine the reverse light power wires for your car, designating the positive and negative wires. If you
are not sure of which are the power wires, then please contact your vehicle manufacturer or reference a
wiring diagram for your vehicle.
7.
Connecting the Power Cable:
a.
Take the open wire end of this cable, and connect it to the power wires of your car (as
determined in step 4). Using the Snap Lock Splice Connectors, connect the adapter’s Red wire to
reverse light’s Positive wire. Connect the adapter’s Black Wire to reverse light’s Negative wire.
b.
Use pliers to squeeze the metal tabs of the Snap Lock Splice Connectors and ensure a solid
connection, then snap the plastic cover closed.
8.
Mount the wireless camera on the license plate adapter. While sitting in the driver’s seat of the car
with the key in the accessory position. The monitor will automatically start when connected to a power
source. If, when you place the vehicle in reverse there is no image, go to the section “Operation” for
more information.