3
Replace the new battery and install the cover back.
1.
Put the front cover bottom to 1-1 and press down.
2.
Push the front cover top to 2-1.
Choosing a Suitable Location
1.
The recommended mounting height is 160cm
2.
Don't let the device facing the window or the sunlight.
3.
Don't let the device facing the source of heat (e.g. heater or air-conditioner).
Installation
1. In the first time, add the device into the Z-Wave
TM
network. First, make sure the
controller is in the inclusion mode. Then power on the device, just take out the insulation
Mylar in the back side of the device. The device will auto start the NWI (Network Wide
Inclusion) mode. It should be included in 5 seconds. LED light goes ON for one second.
2. Let the controller associate with the device into the first group, any light switch that
intend to be turned on when the device trig please associate with the device into the
second group.
3. In the accessory pack. There are two types of double coated tape, one is thicker
(hereinafter referred to as A tape) and another is thinner (hereinafter referred to as B
tape), you can use A tape for the test at the beginning. The right way for A tape
installation is stick it to the position below tamper key. The thicker tape won't let the
tamper key pressed, so the sensor will enter the test mode. You may test if installed
position is good or not by this way.
