Coccolle Silene, User Manual

Page: 14 / 21

EN
In order to assemble the canopy, insert its hooks on the handles on the stroller
frame (fig. 11). Set the canopy in the desired position (fig. 12). The canopy is
equipped with additional for maximum coverage during the full recline position.
In order to reveal it, unzip the top of the canopy.
Using the brake
Assembly and removal of the bumper bar
NOTE! Never move the stroller by holding the seat. In order to remove the seat,
push the buttons located on both sides of its adapters and pull the seat up (Fig.
10).
NOTE! The brake is not designed for slowing down. It should be engaged after
the pram has been stopped completely.
The stroller has swiveling front wheels, which may also be locked in a forward
facing position. To allow the wheels to rotate, move the lever on the front of the
wheel down (fig. 8). To lock the wheels for straight pushing, move the lever
upwards.
NOTE! The pram is not designed for running.
In order to assemble the seat, unstick the seat adapters from the handle on the
stroller frame. The seat can be assembly both facing and back to the direction of
travel (fig. 10).
NOTE! Before starting to push the pram, make sure that the brake has been
disengaged.
To attach the front wheels, push their hubs into the mounts on the ends of the
front tubes (fig. 4). To remove the wheels, press the button on the side of the
wheel holder and pull the hub out of the holder (fig. 5). To attach the rear
wheels, push their hubs into the mounts on the rear suspension (fig. 6). To
remove the wheels press the metal button on the bottom of the wheel mounts
and slide the hubs out (fig. 7).
The pram is equipped with a rear parking brake. To engage the brake, press its
lever down (Fig. 9). In order to disengage it, lift the lever.
ATTENTION! Make sure the wheels are correctly attached prior to use.
NOTE! Always engage the safety brake, when you leave the pram on an
inclined surface.
Swiveling front wheel system
Attaching and removing wheels
Assembly and removing the seat
NOTE! Before usage, make sure that the seat is properly assembled.
Assembly and removing the canopy
In order to assemble the bar, insert its hooks on the handles on the seat side
tubes. In order to remove it, push the buttons located in the lower part of the
handles and slide the clips out (fig. 13).
Remove the bumper bar before folding the pram.
NOTE! Using the bumper bar does not exempt from the obligation of using the
seat belts.
NOTE! Never move the stroller by holding the bumper bar.