Instruction Manual
PERSONAL MINI 3" MP3/CD PLAYER with
120-SECOND ANTI-SKIP PROTECTION
MP-CD800
NAME OF PARTS
ESP
MP3
Insert the disc into the unit with the label of the disc
facing up.
Gently wipe the disc using a soft cloth from the center
to the outer direction to remove dust, fingerprints or any
other particles on the disc surface. Never use
chemicals, such as record sprays, anti-static sprays,
benzene or thinners to clean the CD. These chemicals
c a n d a m a g e t h e d i s c s u r f a c e p e r m a n e n t l y .
To avoid serious scratches on CD, keep them in the
cases after each use. Scratches can cause the laser
pick-up skip in the future play.
Do not place stickers or write anything on the disc.
Ensure that all electrical connections(including the main
plug, extension leads and interconnections between
pieces of equipment) are properly made and in
accordance with the manufacture’s instructions.
Consult your dealer if you are ever in doubt about the
installation, operation or safety of your equipment.
Read the instruction manual before operating this unit.
Do not expose the unit to high temperature or humidity.
Use dampened soft cloth to clean the unit. Do not use
strong detergent or solvent to clean the unit.
Volume to low listening level and press DBBS switch in
the direction of the arrow to turn this function ON.
Note: Some CD’s with DBBS may exceed the bass
response capacity and can cause distortion. Do not play
DBBS in high volume. Playing DBBS in high volume may
cause damage to the headphone and more importantly to
your hearing.
HOLD FUNCTION
This HOLD function prevents any unwanted function
changes during PLAY or STOP mode. Slide HOLD switch
to the arrow direction (or opposite) to turn the function
ON (OFF). No other function buttons operate on HOLD
mode, except DBBS function.
CAUTION
Hearing experts advise against the constant use of
personal stereos played at high volume. Constant high
volume use can lead to hearing loss. If you experience
ringing in the ears or hearing loss, discontinue use and
seek medical advice.
To remove the disc from its storage case, press down on
the center of the case and lift the disc out. Hold it carefully
by the edges as shown below.
DBBS FUNCTION
The Dynamic Bass Boost System(DBBS) enhances the
low frequency(Bass) response of the output. Set the
2. Plug in AC adapter and slide the “CHARGE SWITCH“
to “ON” position to start charging.
3. Unplug the AC adapter after charging.
DO NOT CHARGE THE BATTERIES MORE THAN 24
HOURS OR MORE THAN RECOMMENDED TIME.
OVERCHARGING MAY DETERIORATE THE PERFORM-
A N C E O F T H E R E C H A R G E A B L E B A T T E R I E S .
4. If the operating time decrease drastically after the
batteries have been recharged properly, purchase new
rechargeable NiCd batteries.
Do not attempt to recharge alkaline batteries. This may
cause leakage and damage to the unit.
Do not mix alkaline batteries with rechargeable batteries.
MONEY SAVING TIPS.
Due to the nature of CD technology, the unit uses power
even when the unit is off. To extend the batteries’ life, use
the adapter for indoor operation or where power is
supplied. Use the battery operation only when the unit is in
mobile.
Please read and follow the instruction manual
carefully before operating in order to avoid any
damages to the unit. Any adjustment or repair
should be done by a qualified service center only
to receive warranty.
INTRODUCTION
Your unit operates on two(2) AA size alkaline batteries.
Open the CD cover and insert the batteries in the battery
compartment following the polarity diagram located
inside.
BATTERY OPERATION
(BATTERIES NOT INCLUDED)
RE-CHARGEABLE BATTERY OPERATION
(RE-CHARGEABLE BATTERIES NOT INCLUDED)
You can operate this unit with two “AA” rechargeable
batteries. For new or exhausted rechargeable batteries,
we recommend that (Refer to battery manufacturer’s
guide).
1. Open the CD cover and insert the batteries (2*”AA”) in
the battery compartment following the polarity diagram
located inside.
BOTH BATTERIES MUST BE RECHARGEABLE NiCd
TYPES OTHER BATTERIES MAY EXPLODE OR LEAK.
When operating the unit with AC adapter
and non-rechargeable batteries in the
compartment, please make sure to set the
“Charge” switch to “Off” position to avoid
damaging the unit.
AUTO PLAY
Press PLAY/PAUSE ( )button to turn the power on.
THEN LCD screen will display .
FIRST LCD screen will display .
LCD screen will display "NO DISC", if CD is not in the
unit.
ESP
"MP3" will flash.
ESP
ESP
ESP
LCD screen will display " Er " if the unit
cannot read CD track data.
(3)
PAUSE
Press PLAY/PAUSE button to pause on/off alternately,
time "00:05" and will flash.
(1)
STOP
Press STOP ( )button to stop play , LCD screen will
display the last track number.
LISTEN TO DESIRED TRACK
Press FF (or REW ) button to set the desired
track#, press PLAY/PAUSE ( )button to play. Press
FF (or REW ) button to change the track# during
the play mode.
(1)
Press FF button
When CD track data has been read, LCD SCREEN will display the last
track number with the total play time.
(4)
Unit will start play from No.1 automatically.
(5)
"
ESP
" will flash.
ESP
When a track is finished, before next track play,
LCD SCREEN time will display 04,03,02,01,00,
then begin next track.
(6)
ESP
ESP
ESP
ESP
ESP
ESP
MP3 MODE
IMPORTANT MP3 CD making tips.
Make sure to use mp3 file extension only when burning CDs.
Do not mix audio files and mp3 files within a CD ROM.
The CD mechanism and the sensitive circuitry may
cause interference to a radio tuner nearby. Do not
operate this unit while operating other radio devices.
Danger This product utilizes invisible laser
radiation. Avoid direct exposure
to the beam.
Caution Use of controls, adjustments or procedures
not listed in this manual may result
in
hazardous radiation exposure
.
IMPORTANT
CONCERNING COMPACT DISCS
Only compact discs identified with this
mark can be used with this player.
POWER ON
ESP/DIR. button
HOLD switch
PHONE jack
STOP button
Volume control
OPEN switch
DC IN jack
MODE button
REW button
CHARGE switch
PAUSE button
PROG button
FF button
PLAY button
DBBS switch
