IMPORTANT NOTICE:
WARNING:
Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: 1) This
device may not cause harmful interference, and 2) this
device must accept any interference received, including
interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Safety Information for microTALK Radios
Your wireless handheld portable transceiver contains a low
power transmitter. When the talk button is pushed, it sends
out radio frequency (RF) signals. The device is authorized to
operate at a duty factor not to exceed 50%. In August 1996,
the Federal Communications Commissions (FCC) adopted RF
exposure guidelines with safety levels for handheld wireless
devices.
Important
FCC RF Exposure Requirements: For body-worn operation,
this radio has been tested and meets the FCC RF exposure
guidelines when used with Cobra accessories supplied or
designated for this product. Use of other accessories may
not ensure compliance with FCC RF exposure guidelines. Use
only the supplied antenna. Unauthorized antennas,
modifications or attachments could damage the transmitter
and may violate FCC regulations.
Normal Position:
Hold the transmitter approximately two (2) inches from your
face and speak in a normal voice, with the antenna pointed
up and away.
FCC Part 15.21 Warning Statement-
NOTE:
THE GRANTEE IS NOT RESPONSIBLE FOR ANY
CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED
BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH
MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
IC RSS-GEN
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio excempts de licence.
L;exploitation est autorisée aux deux condtions suivantes:
(1) l’appariel ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Radiation Exposure Statement:
Under ISEDC regulations, this radio transmitter may only
operate using the antenna that is affixed to the radio
transmitter. Use only the supplied antenna. Unauthorized
antennas, modifications, or attachments could damage the
transmitter and may void the user’s authority to operate the
radio.
Any changes of modifications not expressly approved by the
party responsible for compliance could void the user’s ability
to operate the equipment.
SAR tests are conducted using standard operating positions
accepted by the FCC/ISEDC with the device transmitting at
its highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the device while
operating can be well below the maximum value.
This device has been tested and certified to not exceed the
exposure limit established by the FCC/ISEDC. Tests for each
device are performed in positions and locations (e.g. at the
ear and worn on the body) as required by the FCC/ISEDC.
For body worn operation, this device has been tested and
meets the FCC/ISEDC RF exposure guidelines when used
with an accessory designated for this product or when used
with an accessory that contains no metal and that positions
the handset a minimum of 10mm from the body.
Non-compliance with the above restrictions may result in a
violation of RF exposure guidelines
.
Limited One-Year Warranty
Cobra warrants your product against all defects in materials
and workmanship for a period of one (1) year from the date
of original purchase.
Cobra, at our sole discretion, will repair or replace your
product (with the same or comparable product) free of charge.
Cobra will not pay shipping charges that you incur for sending
your product to us. Products received COD will be refused.
To make a warranty claim, we will require proof or purchase
in the form of an invoice or receipt. No proof of purchase is
required for factory direct purchases.
Warranty Exclusions:
Warranty does not apply to your
product under any of the following conditions: 1. The serial
number has been removed or modified. 2. Your product has
been subjected to misuse or damage (including water
damage, physical abuse, and/or improper installation). 3.
Your product has been modified in any way. 4. Your receipt
or proof-of-purchase is from a non-authorized dealer or
internet auction site including E-bay, U-bid, or other
non-authorized resellers.
LIMITATION OF WARRANTY: EXCEPT AS EXPRESSLY
PROVIDED HEREIN, YOU ARE ACQUIRING THE PRODUCT “AS
IS” AND “WHERE IS”, WITHOUT REPRESENTATION OR
WARRANTY. COBRA SPECIFICALLY DISCLAIMS ANY
REPRESENTATION OR WARRANTY INCLUDING, BUT NOT
LIMITED TO THOSE CONCERNING THE MERCHANTABILITY
AND SUITABILITY OF THE PRODUCT FOR A PARTICULAR
PURPOSE. COBRA SHALL NOT BE LIABLE FOR CONSEQUEN-
TIAL, SPECIAL OR INCIDENTAL DAMAGES INCLUDING,
WITHOUT LIMITATION, DAMAGES ARISING OUT OF THE USE,
MISUSE OR MOUNTING OF THE PRODUCT.
The above limitations or exclusions shall be limited to the
extent they violate the laws of any particular state. Cobra is
not responsible for products lost in shipment between the
owner and our service center.
General Warranty Information
Each product we manufacture is covered by our factory
warranty. While each product may have unique components
and policy, the general guideline below will apply to most
Cobra products.
All Cobra products purchased factory-direct or from our
Authorized Resellers will come with a full one to three (1-3)
year warranty from the date of the original retail purchase (see
policy statement above for full warranty details and exclusions).
Standard accessories packaged with each model will have a
one-year factory warranty.
Accessory items have a one-year factory warranty.
Shipping to our facility is not covered in our warranty. Return
shipping is included within the US.
This warranty is non-transferrable.
For the sake of clarity, ‘repair or replace the Product or its
defective part’ does not include removal or installation work,
costs or expenses which include but are not limited to labor
costs or expenses.
Cobra will not be responsible for lost packages.
Customer Assistance
In this user’s guide, you should find all the information you need
to operate your microTALK
®
radio. If you require further
assistance after reading this guide, Cobra offers the following
customer assistance services:
For Assistance In The U.S.A.
Product Service:
For any questions about operating or installing this new
Cobra product, PLEASE CONTACT COBRA FIRST…
do not return this product to the retail store. The contact
information for Cobra will vary depending on the country in
which you purchased and uses the product. For the latest
contact information, please go to www.cobra.com/support or
call 1-800-543-1608.
If your product should require factory service, please go to
www.cobra.com/support and follow the instructions.
For Products Purchased Outside the U.S.A.
Please contact your authorized local reseller or agent for
warranty information.
Trademark Acknowledgment
©2022 Cobra Electronics Corporation. Cobra and the snake
design are proprietary trademarks of Cobra Electronics
Corporation, USA. Other trademarks and trade names are
those of their respective owners.
Cobra Electronics Corporation™ is a trademark of Cobra
Electronics Corporation, USA.
TWO-WAY RADIO MODEL
RX100
Printed in China, Part No. 814-RX1002-101
User’s Guide