Customer Assistance Warranty
Introduction
Operation
10
Mode Functions
Operation
11
Set DCS Privacy Codes
•
To select a DCS privacy code:
1.
After selecting a channel, press the
Mode
button until the DCS icon appears and the small
numbers flash on the display
(01 through 104).
NOTE
If CTCSS is turned
on
at the channel
selected, the display will flash the
DCS icon and “OFF.” To switch from
CTCSS to DCS, press the
Channel Up
or
Channel Down
button while the display
is flashing “OFF.” The display
will then show the small numbers flashing
and you will then be able
to proceed to step 2.
2.
Press using the
Channel Up
or
Channel Down
button to select a DCS privacy code. You can hold
the
Channel Up
or
Channel Down
button for fast
advance.
3.
When your desired DCS privacy code is displayed,
choose one of the following:
a.
Press the
Mode
button to enter the new
setting and proceed to other functions.
b.
Press the
Lock/Enter
button to enter the new
setting and return to
Standby
mode.
c.
Do not press any buttons for 15 seconds
to enter the new setting and return to
Standby
mode.
NOAA* All Hazards Radio Channels
•
You can use your microTALK radio to listen to
NOAA All Hazards Radio
channels transmitting in your area.
To listen to All Hazards Radio channels:
1.
Press the
Mode
button until the
WX
(All Hazards
Radio) icon, the currently selected All Hazards
Radio channel, and signal strength are displayed.
2.
Use the
Channel
Up
or
Channel
Down
button to
change All Hazards Radio channels.
3. WX
(All Hazards Radio) icon will continue to be
displayed when All Hazards Radio is
on
. Choose
one of the following:
a.
Press the
Mode
button to proceed
to other functions.
b.
Press the
Lock/Enter
button to exit
All
Hazards Radio
channels mode and return to
Standby
mode.
*National Oceanographic and Atmospheric Adminstration
Mode Button
Channel Buttons
DCS Privacy Code
Mode Button
Channel Buttons
Hazards Radio Icon
