3
3
2
2
For charging microTALK radio(s) in desktop
charger:
1.
Insert radio(s) into desktop charger as shown.
2.
Insert round connector of 120-volt adapter
into jack on back of charger.
3.
Plug 120-volt adapter into electrical outlet.
If charging light is not
on
, check position of radio. Radio should be
upright. The charge indicator light will stay
on
as long as the radio
is in the charging well
.
It normally takes about 15 hours to fully recharge battery pack.
Battery pack will not be damaged if it stays in the charging well
longer than that.
Note:
To charge a single radio, you can bypass the desktop charger
and simply insert the wall adapter’s round connector directly into
the speaker/microphone/charge jack located on the top of the radio.
Use only the supplied rechargeable batteries and charger for
recharging your Cobra microTALK radio.
Cobra recommends your radio is turned
o
offff
while being charged.
Turning on Your microTALK Radio
•
•
Press and hold the
Power
button until you
hear a series of audible tones indicating the radio
is
on
.
Your microTALK radio is now in
Standby
mode, ready to receive transmissions. The radio
is always in
Standby
mode, except when the
Talk
,
Call
,
Mode
or
Power
buttons are pressed.
Battery Low
•
•
When battery power is low, the
Battery Low
icon
will blink. Your batteries should be recharged.
Auto Battery Save
•
•
Your microTALK radio has a unique circuit
designed to extend battery life. If there are
no transmissions for 10 seconds, the radio will
automatically switch to
Battery Save
mode and
the
Power Saver
icon will flash in the display.
This will not affect the radio’s ability to receive
incoming transmissions.
Communicating with Another Person
•
•
1.
Press and hold the
Talk
button.
2.
With the microphone about 2 inches
(5 cm) from your mouth, speak in a
normal voice.
3.
Release the
Talk
button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the
Talk
button.
Both radios must be tuned to
the same channel/privacy code
to communicate.
IIn
nttrro
od
du
uc
cttiio
on
n
U
Us
siin
ng
g Y
Yo
ou
urr R
Ra
ad
diio
o
Customer Assistance
Warranty
Introduction
O
Op
pe
erra
attiio
on
n
IIn
ns
se
errtt R
Ra
ad
diio
o((s
s))
O
On
n//O
Offff P
Po
ow
we
err
B
Ba
atttte
erry
y L
Lo
ow
w
B
Ba
atttte
erry
y S
Sa
av
ve
e M
Mo
od
de
e
T
Ta
allk
k B
Bu
utttto
on
n
2
2 IIn
nc
ch
he
es
s ((5
5 c
cm
m))
ffrro
om
m M
Mo
ou
utth
h
Quick Start
1.
Press and hold the
Power
button to turn
on
your radio.
2.
Press the
Channel Up
or
Channel Down
button to select a channel.
Both radios must be tuned to the
same channel/privacy code to
communicate.
3.
Press and hold the
Talk
button while
speaking into the microphone.
4.
When finished talking, release the
Talk
button and listen for a response.
