IMPORTANT NOTICE:
WARNING: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user’s authority to operate the
equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: 1)
This device may not cause harmful interference, and 2)
this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Safety Information For microTALK
®
Radios
Your wireless handheld portable transceiver contains a
low power transmitter. When the Talk button is pushed, it
sends out radio frequency (RF) signals. The device is
authorized to operate at a duty factor not to exceed
50%. In August 1996, the Federal Communications
Commissions (FCC) adopted RF exposure guidelines
with safety levels for handheld wireless devices.
Important:
FCC RF Exposure Requirements: For body-worn
operation, this radio has been tested and meets the FCC
RF exposure guidelines when used with Cobra
accessories supplied or designated for this product. Use
of other accessories may no ensure compliance with
FCC RF exposure guidelines. Use only
the supplied antenna. Unauthorized antennas,
modifications, or attachments could damage the
transmitter and may violate FCC regulations.
Normal Position:
Hold the transmitter approximately two (2) inches from
your face and speak in a normal voice, with the antenna
pointed up and away.
FCC Part 15.21 Warning Statement-
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY
CHANGES OR MODIFICATIONS NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR
COMPLIANCE. SUCH MODIFICATIONS COULD VOID
THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT.
IC RSS-GEN
This device complies with ISEDC license-exempt RSS
standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference,
and (2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
Under ISEDC regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by ISEDC. To
reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
The applicant is responsible for providing proper
instructions to the user of the radio device, and any
usage restrictions, including limits of exposure durations.
The user manual shall provide installation and operation
instructions, as well as any special usage conditions, to
ensure compliance with SAR and/or RF field strength
limits. For instance, compliance distance shall be clearly
stated in the user manual.
Radiation Exposure Statement:
Any Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
For Remote controller, SAR tests are conducted using
standard operating positions accepted by the
FCC/ISEDC with the device transmitting at its highest
certified power level in all tested frequency bands,
although the SAR is determined at the highest certified
power level, the actual SAR level of the device while
operating can be well below the maximum value.
Before a new model device is available for sale to the
public, it must be tested and certified to the FCC that it
does not exceed the exposure limit established by the
FCC/ISEDC, Tests for each device are performed in
positions and locations (e.g. at the ear and worn on the
body) as required by the FCC/ISEDC.
For body worn operation, this model device has been
tested and meets the FCC/ISEDC RF exposure
guidelines when used with an accessory designated for
this product or when used with an accessory that
Contains no metal and that positions the handset a
minimum of 10 mm from the body.
Non-compliance with the above restrictions may result in
violation of RF exposure guidelines.
Product Service and Support
For any questions about operating this new Cobra
branded product, PLEASE CONTACT US FIRST… do not
return this product to the retail store. The contact
information for support will vary depending on the
country in which you purchased and utilize the product.
To obtain warranty service or other information for
products purchased from Altis itself or through its
authorized reseller or agent and utilized in the U.S.A.,
please call our consumer support line at (866) 721-3805,
or email us at [email protected]. You will receive
instructions on how to ship the products at your expense
to an Altis Global Limited Authorized Service Center. To
obtain service, you must include: (a) a copy of your
receipt, bill of sale or other comparable proof of
purchase; (b) a written description of the problem; and,
most importantly; (c) your address and telephone
number.
For warranty and customer service information outside
the US, please contact your local dealer.
For further information needed on its features, please
visit www.cobrawalkietalkie.com for frequently asked
questions and the electronic manual.
Trademark Acknowledgement
Manufactured, distributed, or sold by Altis Global
Limited, official licensee for this product. Cobra
®
,
microTalk
®
, Nothing Comes Close to a Cobra
®
, and the
snake design are registered trademarks of Cobra
Electronics Corporation, USA. Cobra Electronics
Corporation™ is a trademark of Cobra Electronics
Corporation, USA. All other product or service names are
the property of their respective owners.
© Cobra Electronics Corporation, USA 2019. All rights
reserved.
Limited One-Year Warranty
Altis Global Limited warrants to the original consumer
purchaser only that this product and the component
parts thereof, will be free from defects in workmanship
and materials for a period of one year from the date of
first consumer purchase. During this period, Altis will,
repair or replace, at its sole option and discretion, this
product or any defective parts. Altis’ liability hereunder
shall be limited to repair or replacement of the defective
part or parts, and such correction shall constitute a
fulfilment of all of Altis’ warranties hereunder.
This limited warranty is only valid for the original
consumer purchaser in limited jurisdictions and is not
transferrable. This limited warranty will automatically
terminate prior to expiration if this product is sold or
otherwise transferred to another party. The product must
be purchased from Altis or an authorized dealer or the
warranty is void. This limited warranty is valid only for
products purchased and utilized in specific jurisdictions.
Please visit our website at www.cobrawalkietalkie.com
for a list of jurisdictions wherein this limited warranty is
valid.
This limited warranty does not cover damage due to
misuse, abuse, negligence, acts of God, accident,
commercial use or modification of, or to any part of this
product. This warranty does not cover damage due to
improper operation, maintenance or installation; ordinary
wear and tear; or attempted alterations or repairs by
anyone other than Altis or someone authorized by Altis to
do warranty work. Any unauthorized alterations or
repairs will void this warranty. This limited warranty does
not cover product sold AS IS or WITH ALL FAULTS. This
limited warranty is invalid if the factory applied serial
number or date stamp has been altered, defaced or
removed from this product. This limited warranty does
not cover product purchased or utilized in a jurisdiction
not covered.
The procedure for obtaining service and support, and the
applicability of this warranty, will vary depending on the
country or jurisdiction in which you purchase and utilize
the product. For details on obtaining product service,
support and other warranty information please visit
www.cobrawalkietalkie.com.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state
and country to country.
EXCEPT AS EXPRESSLY SET FORTH IN THIS
WARRANTY, ALTIS MAKES NO OTHER WARRANTIES,
EXPRESSED OR IMPLIED, INCLUDING ANY IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE. ALTIS EXPRESSLY
DISCLAIMS ALL WARRANTIES NOT STATED IN THIS
LIMITED WARRANTY. ANY IMPLIED WARRANTIES
THAT MAY BE IMPOSED BY LAW ARE LIMITED TO THE
TERMS OF THIS EXPRESSED WARRANTY.
LIMITATION OF REMEDIES AND DAMAGES. REPAIR
OR REPLACEMENT AS PROVIDED UNDER THIS
WARRANTY IS THE EXCLUSIVE REMEDY OF THE
CONSUMER. ALTIS SHALL NOT BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES,
INCLUDING BUT NOT LIMITED TO ATTORNEYS’ FEES
AND/OR COSTS OF LITIGATION, FOR BREACH OF ANY
EXPRESS OR IMPLIED WARRANTY ON THIS
PRODUCT. ALTIS IS NOT LIABLE FOR ANY DAMAGES
CAUSED BY THE PRODUCT OR BY THE PRODUCT TO
PERFORM, INCLUDING ANY LOST PROFITS, LOST
SAVINGS, INCIDENTAL DAMAGES, OR
CONSEQUENTIAL DAMAGES. ALTIS IS NOT LIABLE
FOR ANY CLAIM MADE BY A THIRD PARTY OR MADE
BY YOU FOR A THIRD PARTY. THIS LIMITATION
APPLIES WHETHER DAMAGES ARE SOUGHT, OR A
CLAIM MADE, UNDER THIS WARRANTY OR AS A TORT
CLAIM (INCLUDING NEGLIGENCE OR STRICT
PRODUCT LIABILITY), A CONTRACT CLAIM, OR ANY
OTHER CLAIM. THIS LIMITATION CANNOT BE WAIVED
OR AMENDED BY ANY PERSON. THIS LIMITATION OF
LIABILITY WILL BE EFFECTIVE EVEN IF ALTIS OR AN
AUTHORIZED REPRESENTATIVE OF ALTIS HAS BEEN
ADVISED BY YOU OF THE POSSIBILITY OF ANY SUCH
DAMAGES.
Some states and countries do not allow limitations on
how long an implied warranty lasts and do not allow the
exclusion or limitation of incidental or consequential
damages, so the above limitations may not apply to you.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state
and country to country.
Provided that the product was purchased from Altis itself
or through its authorized reseller or agent and utilized in
the U.S.A., Altis will, without charge, repair or replace, at
its option, defective products, products or component
parts upon delivery to the authorized Altis Global Limited
Authorized Service Center, accompanied by proof of the
date of first customer purchase, such as a duplicated
copy of a sales receipt.
You must pay any initial shipping charges required to
ship the product for warranty service, but the return
charges, to an address in the U.S.A, will be at Altis’
expense, if the product is under warranty.
For Products Purchased Outside the U.S.A.
Please contact your authorized local reseller or agent for
warranty information.
User’s Guide
TWO-WAY RADIO MODEL
CX190
Printed in China, Part No. KEM-KEM-ML38101-19
