- 24 -
b) Start the engine and let it run until it has used up all remaining petrol and stalls.
c) Remove the spark plug. Use an oilcan to fill approx. 20 ml oil into the combustion chamber. Operate the
starter to evenly distribute the oil in the combustion chamber. Replace the spark plug.
2. Clean and grease the lawnmower carefully as described above under “Lubrication”.
3. Slightly grease the cutter to avoid corrosion.
4. Store the lawnmower in a dry, clean and frost-protected place, out of reach of unauthorised persons.
CAUTION!
The engine must have completely cooled down before storing the lawnmower.
NOTE:
- When storing any type of power equipment in an unventilated or material storage shed,
- Care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the equipment, especially
cables and all moving parts.
- Be careful not to bend or kink cables.
- If the starter rope becomes disconnected from rope guide on the handle, disconnect and ground the spark
plug wire, Depress the blade control handle and pull the starter rope out from engine slowly. Slip the starter
rope into the rope guide bolt on the handle.
Transport
Turn the engine off and allow the engine to cool down. Then disconnect the spark plug wire and empty the
fuel tank according to the instructions in the engine manual. Ensure not to bend or damage the cutter when
pushing the lawnmower over obstacles.
Summary of Contents for G48SHLVE-C
Page 29: ...29...
