!AWARNING!
The saw chain has very sharp edges. Use thick protective gloves for safety.
1. Pull the guard towards the front handle to check that the chain brake is not on.
2. Loosen the nuts and remove the chain cover.
3. Install the attached spike to the power unit.
F2 ... .,.
.
,· .
(2) Loosen Direction
(3) Tighten Direction
(4) Tensioner screw
4. Gear the chain
to
the sprocket and, while
fitting the saw chain around the guide bar,
mount the guide bar to the power unit. Fit the
chain tensioner bar(9) to the lower hole(B).
Adjust the position of chain tensioner bar(9)
on the chain cover to the lower hole(8) of the
guide bar.(F2)
(10) Chain cover
(9)
Tensioner Bar
(8)
Hole
!NOTE!
F3 • (1)Chain Moving Direction
Pay attention
to
the correct direction of
the saw chain.(F3)
5. Fit the chain cover to the power unit
and fasten the nuts
to
finger tightness.
6. While holding up the tip of the bar,
adjust the chain tension by turning the
tensioner screw until the tie straps just
touch the bottom side of the bar rail.(F4)
7. Tighten the nuts securely with the bar
tip held up (12-15Nm). Then check the
chain for smooth rotation and proper
tension while moving it by hand. If
necessary, readjust with the chain cover
loose.
8. Tighten the tensioner screw.
