Set The Clock
Press and hold the button that says
”Clock” and VOICE HELP will direct you
to press the “SKIP” button until you
hear the correct day of the week, then
release. Press and release ”Clock” again,
then SKIP or REPEAT button until the
correct hour is displayed in the LED
window. Repeat again for the minutes.
Press ”Clock” again and VOICE HELP will
verify the time that has been set. Every
message received will then be identified
by day of the week and time.
Record your
outgoing message
Check to be sure the ICM (Incoming
Message) Recording switch on the side of
the phone is set at “2 Min.” (as opposed
to “Annc Only”). Press and hold the
button that says “OGM” (Outgoing
Message) and VOICE HELP will direct you
to start recording your message after the
beep. The LED display window will
indicate the length in seconds; you have
up to 60 seconds recording time for your
OGM. Speak about 6 inches from the
microphone located in small slot on front
of base. Release the button and your
message plays back. Not satisfied with
your message? Simply follow these steps
over again and keep recording your
outgoing message until you’re
comfortable.
Cobra
®
Now that your new Cobra Intenna Cordless
Phone Answering System is out of the box
and ready to use, here are some things
you’ll need to be aware of before getting
started.
Location
Be sure the location you‘ve chosen is near
both an electrical outlet and a telephone
wall jack—both are required to connect your
new Cobra Telephone Answering System.
Maximum range is obtained by locating the
base as high as possible in your home.
Charging
After connecting, and before using the
handset of your new system, it will need to
rest in the base overnight (at least 12 hours)
in order to charge.
Ringer
Make sure the RINGER switch, located
on the rear of the base, is set to ON.
Pulse/Tone
Set the PULSE/TONE switch, located
on the rear of the base, to the operation
that is correct for your installation.
Keep This Guide
Put this guide in a handy place. You may
want to refer to it for information when
using or programming different features of
your Cobra Intenna Cordless Telephone
Answering System.
Battery Back Up
Now‘s the time to put your 9v back-up
battery (included) into the base. Simply
open the battery compartment located
below the handset on the base, plug-in
the battery, and your outgoing and
incoming messages will be saved
during power outages or other
disconnections.
1-773-889-3087
NEED HELP
?
SOME THINGS YOU NEED TO
KNOW BEFORE YOU GET STARTED
GETTING SET UP...
IT’S AS EASY AS 1-2-3
1
1
2
2
4
3
4
6
5
9
6
5
9
7
RINGER
3
BATTERY
BACK UP
CLOCK
BUTTON
SKIP
BUTTON
ICM
RECORDING
SWITCH
7
REPEAT
BUTTON
OGM
BUTTON
10
10
8
8
LED DISPLAY
PULSE/
TONE
▼ ▼
▼
▼
Plug it in
Plug the adapter cord into the power jack
on the rear of the base, then plug the
adapter into any standard 110V outlet.
(VOICE HELP will direct you to set clock
and outgoing message).
Set the handset
on the base to charge and in 12 hours
you’re ready to make and receive calls.
The Answering System will work while
the telephone handset is charging.
REPEAT SKIP
AN8630-25
Cobra
®
