COMPLETE INSTRUCTIONS
G100-G300
69
radiocontrol device that was already operating must also be re-memorized by the
system).
9.
If no operation is performed for over 30 s the system automatically exits the self-
learning mode and signals that it has exited the procedure with a long flash of the
direction indicators.
10.
To exit the procedure voluntarily, it is necessary to close the bonnet. This operation
can be performed at any time.
G300
15.2
- Procedure for adding new driver cardss (self-learning).
If a driver card is lost or is not operating properly, it is possible to replace it but only under
secure conditions as this operation is only allowed in particular circumstances. Proceed
as follows:
1.
Disarm the system.
2.
Open a door and the bonnet.
3.
Turn on the ignition.
4.
Key in the PIN code.
5.
The system will confirm that you have accessed the self-learning procedure by
another flash of the direction indicators and by lighting up the system LED.
6.
Key in the PIN code.
7.
The system will confirm that you have accessed the self-learning procedure by
another long flash of the direction indicators and by lighting up the system LED
with a steady light.
8.
Press the key on the driver card, checking that the driver card LED flashes and
that the LED on the emergency panel stops shining for approximately 1 s; the
direction indicators will also give a short flash to confirm that the driver card has
been memorized.
9.
Repeat step 8 for every driver card you want to enable (the driver card that was
already operating must also be re-memorized).
10.
If no operation is performed for over 30 s the system automatically exits the self-
learning mode and signals that it has exited the procedure with a long flash of the
direction indicators.
11.
To exit the procedure voluntarily, it is necessary to close the bonnet. This operation
can be performed at any time.
PAGE 1
A
G100
PROGRAMMING NEW RADIO CONTROLS
BASIC F
UNCTIO
NS TABL
E
06DE2373Acorrect version.pmd
16/03/2007, 11.07
69